Forum Discussion
How To Turn Off Drill Through on Visual
Hi Anonymous ,
Try to set the drill-through destination conditionally:
Best Regards,
Liang
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
Go to the page - RFIDNACCEPtoBCMDetails and on visualisation pane remove the measure used from Drill through section.
This way you can remove the drill through.
Also there is no such option as of now to show only selective pages in the list of drill through pages.
Thanks Anonymous for your response. However that's not quite the solution I was looking for. Hopefully in future updates, there will be an option to select drill through pages.
V-lianl-msftCommunity Support
Hi Anonymous ,
Try to set the drill-through destination conditionally:
Best Regards,
Liang
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.Thank you V-lianl-msft, this might be the perfect solution I was looking for. Will test it. Thanks again:)