Forum Discussion
Filtering visuals using slicers combinations
Hi Bimbone ,
Thank you for reaching out to us on the Microsoft Fabric Community Forum.
Please post regarding the same in the issues forum for wider visibility:
Issues - Microsoft Fabric Community
If this post was helpful, please give us Kudos and consider marking Accept as solution to assist other members in finding it more easily.
Hi freginier
Thank you again - now the measure works, however I still cannot get the intended result.
Maybe it's due to the fact that the slicer on the city is pointing to another table (not directly connected to CoppeCitta, but with another table in the middle...)
I will try to look for some simplification on the model...
Thanks anyway for your help!
Hi Bimbone ,
May I ask if you have resolved this issue? If so, please mark the helpful reply and accept it as the solution. This will be helpful for other community members who have similar problems to solve it faster.
Thank you.
Hi,
unfortunately, it did not fully work. Still looking on some other ways to solve.
Hi Bimbone ,
Thank you for reaching out to us on the Microsoft Fabric Community Forum.
Please post regarding the same in the issues forum for wider visibility:
Issues - Microsoft Fabric Community
If this post was helpful, please give us Kudos and consider marking Accept as solution to assist other members in finding it more easily.