Forum Discussion
Filter not working as expected
Community SupportHi Anonymous ,
As tested here,it works fine,no error returns.
Could you pls share your .pbix file for test?Remember to remove the confidential information.
For my .pbix file,pls see attached.
Best Regards,
Kelly
Did I answer your question? Mark my post as a solution!
Thanks for your response, but I can't share my PBIX file. But the issue is that in my file a one to one relationship between "Type" is not being accepted as a valid one and others have a circular dependency issue. And I have a date and type filter (from table 1) on the page which aren't working if they're not having an active relationship between the types or dates.
- v-kelly-msft
Hi Anonymous ,
Could you pls show some sample data with expected output?
Best Regards,
KellyDid I answer your question? Mark my post as a solution!
Hi v-kelly-msft,
I can only attach the screenshots since I don't have an attach file option available. The slicers for type and date are from original table and the graph needs to be filtered by both the slicers which is not happening. The only relationship allowed between "Type" of the tables is many to many and then the graph does not get filtered by the date slicer. I tried creating columns in both the tables to have matchable dates - monthly 1st date in original date and a combinevalue column in summarized table and then create a relationship which is not accepted.
- v-kelly-msft
Hi Anonymous ,
If so,create a dimensional table for "Type":
dim table = VALUES('Original table'[Type])Then create relationships as below among the three tables:
Best Regards,
KellyDid I answer your question? Mark my post as a solution!