Forum Discussion
Drillthrough Button for Card Help/Advice
andybamber - Are you using conditional drill though (drill through action assigned to the button) ? Check if the chart dimenstions are added to the destination page drill through fields.
Did I answer your question? Mark my post as a solution! If not, please feel free to ask me.
Also, I would ❤ Kudos if my solution helped. It is a token of appreciation!
Thank you very much !
Hi There!
so, my original post wasn't clear... I should have said that i can assign page navigation to the button, which works but obviously doesnt pass any contect... when i set the action on the button to drill through, and set the destination page as shown below.. when you hover over the button it just says 'to drill through to Low Usage a single data point for the measure needs to be selected' the measure i'm using on the card isn't used in any of the other visual