Forum Discussion
Difference between 2 columns in a Matrix Table - DAX Help ASAP
- 9 years ago
Hi all,
In case anyone has a similar issue. there is a pretty simple fix. Instead of Using Month.No I should have used [Date].[Date] in all of the formulas.
I apologies for wasting all of your time on this.
Thanks,
Boycie92
Hi Boycie92,
Could you share a sample pbix file which can reproduce the issue in this case? So that we can help to investigate this issue. You can upload it to OneDrive or Dropbox and post the link here or just send me the link in private message. Do mask sensitive data before uploading.:smileyhappy:
Regards
Hi v-ljerr-msft
Please accept my apologies for the delay.
I have created a sample file and data set for you.
You can see that when you compare Department 1 from September to December it shows the same figure?
However in actual fact December should have 0 Values?
Thanks again for your time and patience.
https://www.dropbox.com/s/6qqdg5ea02ivtce/New%20Compressed%20(zipped)%20Folder.zip?dl=0
- Boycie929 years agoResolver I
Hi v-ljerr-msft
I was wondering if you have had the time to look at the issues I am having?
Thanks,
Boycie92
- v-ljerr-msft9 years agoMicrosoft Employee
Hi Boycie92,
I am the one to apologise. Sorry for the delay response.
I did spend a lot time looking into your shared pbix file. Then I found the issue may relate to the previous logic of your measures which are a little complex for me to understand. After a few try, I was still not able to fix your issue. :smileymad:
Regards
- Boycie929 years agoResolver I
Hi v-ljerr-msft
Thanks for looking into this for me.
I am a little bit confused. Do you know why this error was not showing when I used the Month instead of YearMonth?
Thanks again,
Boycie92