Forum Discussion
Post ProdigyDate range slicer (or other data range user interface) to be updated automatically
Most Valuable ProfessionalHi JustinDoh1,
have you enabled the following option?
"Don't allow end user to save filters on this report."
Post Prodigymwegener I was expecting the date range starts from 6/29/2021, but it still stays at 6/28/2021 this morning (after daily data refresh). I don't think it would suffice my requirement... Thanks!
- mwegener
Hi JustinDoh1 ,
is the selection cleared on the slicer?It is important that the slicer has not saved any preselection and only displays the value range set via the filter. Therefore, users should not be able to save slicer/filter settings.
- JustinDoh1
mwegener Thank you again! (and for your prompt response). I don't see that option on Slicer itself, but I see "Clear Filter" option in "14 Days Reports" measure. So, I cleared the filter.
After clearing filter:
But, I see this behavior. Even though the slicer moves by itself, the date range (ex: 6/27/2021) does not seem to get adjusted, but that was my requirement...
I modified the slicer so that I do not use the measure anymore. Now I see "Clear Filter" option is available on Slicer itself. But, when I clear it, it obvisously cleared the visual (it displays all avialable date range).