Forum Discussion
Count between start and end date
Hi joshcomputer1 ,
Your measure is correct however your datetable needs to be disconnected from your Test Table.
Since you have a relationship on the Start Date your data is filtered by the start date only so give you 6 as a result and not the expect outcome.
Check the image below and PBIX file attach:
Regards,
MFelix
Hi joshcomputer1 ,
Your measure is correct however your datetable needs to be disconnected from your Test Table.
Since you have a relationship on the Start Date your data is filtered by the start date only so give you 6 as a result and not the expect outcome.
Check the image below and PBIX file attach:
Regards,
MFelix
Hi MFelix ,
I know this is a few years old but super helpful. Thank you.
Using your example I was able to make it for my use case. However, if I put the data in a bar chart with calendar as X and the measure as Y it and a slicer with the calendar it works great. However, since it's a discconnected table I am not able to click on the chart to filter a table. Is that possible?
for example:
I'm tracking staff on trips with a start and end date. Each trip has a unique ID. I want to be able to see on a chart the number of trips that are occuring at any given month and when i click that month it will filter my table to show me who is traveling. Your example shows the correct data on the chart but it doesn't filter back the table. Wondering how one would tackle that with it being disconnected.
Thanks for taking the time to answer a question from 2019..
Hi RoofTopNomad ,
In this case just try to add the metric on the table visualization filters and set the filter to is not blank. This should give you the expected result that is filtering the records based on the metric selection.
Of course! What an obvious solution! Thanks