Forum Discussion
Combined Table - Query Editor Refreshes But Dataset Doesn't
So, I used Table.Combine to combine to like tables and it worked fine. When I refresh all data in Query Editor the combined table shows updated information. When I do a close and apply and go look in the data window, I see the table didn't update. The only change I made was to the column labeled "Targets" The old targets were 100% and that's where it seems to be stuck in the data and visualizations windows. Yes I hit refresh everywhere from the data window, query editor, relationship window, .... I'm not getting any error messages but I can see the table didn't update. I better mention: Yes, the combined table is marked to enable load and to include in report refresh.
Here's the image in query editor showing the target should now be 90%
In the Data window you can see it's stuck at 100% which was the old target.
I'll be sure to watch for responses and mark the one that works. Thank you so much.
Though I didn't get any responses do directly fix my problem, I was able to figure it out myself. It turned out that the data type for my actuals column in each table needed to be formatted with a type such as percentage in order for the combined table to update that column.
2 Replies
Hi lon0316 ，
Go to query editor >advanced editor:
Check whether your added steps have been written inside:
Best Regards,
KellyDid I answer your question? Mark my post as a solution!Though I didn't get any responses do directly fix my problem, I was able to figure it out myself. It turned out that the data type for my actuals column in each table needed to be formatted with a type such as percentage in order for the combined table to update that column.
