Bug(?) with the callout value for Gauge visuals

[Retrorock]

Not sure if it is a bug or not, but I encountered a very weird issue with the callout value for Gauge visuals.

So the callout value for the Gauge visual, after it displays an Infinity value

if I change the filters to something where it should show a value it will display NaN instead , you can tell it should be showing a value because the gauge changes to somewhere below 100%.

Heck when I hover over the NaN it will show me the correct value 

The NaN callout value won't change until I go into focus mode and quit, then the callout value magically resets to the correct value. I did not change anything, filters or otherwise, in between going into focus mode and quitting. 

[amitchandak]

@Retrorock , Can you share values/measures you have used in Value/Target or Minimum/Maximum value

[Retrorock]

I only have value % MTD Target on my visual

 % MTD Target  is just [MTD]  divided by [Target]

The Target for this month was not populated yet, thats why it was originally showing Infinity, but when i filter the other periods or dates, it should be showing the percentage but instead it will display NaN until I focus on it or change to another tab. It was very weird.