Forum Discussion

walnei's avatar
walnei
Helper III
8 years ago
Solved

AVERAGE TIME

Hello could you help me with the following measure. I want to calculate the average time of each lap of the pilots according to print. I have a Total Time measurement and another Measure with the Num...
Need Help
  • alexei7's avatar
    alexei7
    8 years ago

    Hi walnei,

     

    I found it quite hard to replicate your data as my Power BI didnt like times that went beyond 24 hours, however i've come up with a solution that works for me. There may be a simpler way of doing this, so someone else may be able to help with this

     

    This post was helpful to me.

     

    Create the following custom columns:

     

    1: Seconds = right(Table1[TIME TOTAL],2)

    2: Minutes = mid(Table1[TIME TOTAL],4,2)

    3. Hour = left(Table1[TIME TOTAL],2)

    4. Transfertoseconds = Table1[Hour]*60*60+Table1[Minutes]*60+Table1[Seconds]

    5. NewTime = FORMAT(Table1[Transfertoseconds]/86400,"Short Time")

     

    And then your "TEMP MED LAPS" just uses the NewTime calculation, so:

     

    TEMP MED LAPS = FORMAT(DIVIDE(sum(Table1[NewTime]),sum(Table1[LAPS])), "HH:MM:SS")

     

    Replacing the emoji as per my other comment.

     

    Hope that helps,

    Alex

     

     

walnei's avatar
walnei
Helper III
8 years ago

When the total time passes 24 hours it will reset the value and start again. Example, if you have 25 hours it seems like 1 hour, if you have 28 hours it will appear 4 hours.

 

 

alexei7's avatar
alexei7
Continued Contributor
8 years ago

Hi walnei,

 

I found it quite hard to replicate your data as my Power BI didnt like times that went beyond 24 hours, however i've come up with a solution that works for me. There may be a simpler way of doing this, so someone else may be able to help with this

 

This post was helpful to me.

 

Create the following custom columns:

 

1: Seconds = right(Table1[TIME TOTAL],2)

2: Minutes = mid(Table1[TIME TOTAL],4,2)

3. Hour = left(Table1[TIME TOTAL],2)

4. Transfertoseconds = Table1[Hour]*60*60+Table1[Minutes]*60+Table1[Seconds]

5. NewTime = FORMAT(Table1[Transfertoseconds]/86400,"Short Time")

 

And then your "TEMP MED LAPS" just uses the NewTime calculation, so:

 

TEMP MED LAPS = FORMAT(DIVIDE(sum(Table1[NewTime]),sum(Table1[LAPS])), "HH:MM:SS")

 

Replacing the emoji as per my other comment.

 

Hope that helps,

Alex

 

 

  • walnei's avatar
    walnei
    Helper III
    8 years ago

    Thanks a lot for the help. Was really good