Output virtual dax table

[Do5779]

Hello Experts, 

is there a possibility to get the created virtual table as an output? Power Bi only  says, that more than one value can not be an output of a scalar number.

The problem is the following one: I am writing a dax-measure, but can't check if the dax command is doing what I want ( no I don't have DaxStudio so far). So I want to check the single steps of the calculation respective the created coloumn of my virtual table.

Tahnks a lot. 

[FreemanZ · Accepted solution]

Hi @Do5779 

use the same code to create a table, instead of a measure.