Slicer and card measure interaction problem

[Anonymous]

I have gone through the forum and have not been able to find a solution. I have a Date and Area slicer on one page. All of the date and area values are in the same table. The date slicer works fine, but the area value does not. It returns the proper value for the selection; however it does not exclude the other values. For example, if I select area 2, I will get the proper value for area 2. However, it also provides values for the other areas when it should provide none except for the all calculation which matches the selection as it should . How can I fix this? I have tested removing the date slicer and the same thing happens. I have tried changing the measure calculations and that has not worked either. 

No Selection

Area 4 selection

Area 4 measure calculation

[Anonymous · Accepted solution]

For anyone that might need it later, I just created a separate table for area and used that for the slicer. Everything works well now. 

AreaTable = VALUES('Area Counts'[Area])