Forum Discussion

Anonymous's avatar
Anonymous
Not applicable
6 years ago
Solved

Show average per rows

Hi there, I have this table and I would like to add column that hold Avg Dist per row based on slicer selection And add a flag if Dist > Avg then 1 else 0 I couldn't get the average listed per row...
Need Help
  • d_gosbell's avatar
    d_gosbell
    6 years ago

    VasTg that's a slightly different issue, the data set posted by the OP did not have any blanks.

     

    If you are facing this issue you probably need to explicitly check for blank distances using something like the following.

     

    eg.

     Avg Dist = 
IF( NOT( ISBLANK( 'Table'[Distance] ) )
    , CALCULATE(AVERAGE('Table'[Distance]),ALLSELECTED('Table'))
)

     

  • Anonymous's avatar
    Anonymous
    6 years ago

    Jay,
    Thank you for your response, I address the blank issue for calculating Averages from previous comment
    Also to work around the total above distance I did
    Above Dist = Calculate(
        count(EmpDistance[EmployeeID]),
        filter(EmpDistance, EmpDistance[Distance] > [Average Dist]))
    Which gave me the to
    Thanks,
    OdedDror

VasTg's avatar
VasTg
Icon for Memorable Member rankMemorable Member
6 years ago

d_gosbell 

 

I tried that option. but it shows all the empID as below.. 

 

 

P.S: I am not the OP.

d_gosbell's avatar
d_gosbell
Icon for Super User rankSuper User
6 years ago

VasTg that's a slightly different issue, the data set posted by the OP did not have any blanks.

 

If you are facing this issue you probably need to explicitly check for blank distances using something like the following.

 

eg.

 Avg Dist = 
IF( NOT( ISBLANK( 'Table'[Distance] ) )
    , CALCULATE(AVERAGE('Table'[Distance]),ALLSELECTED('Table'))
)

 

  • Anonymous's avatar
    Anonymous
    Not applicable
    6 years ago

    Hi there,

    I could not bring your IF( NOT( ISBLANK( 'Table'[Distance] ) ) -- It looking for measure

    so I did

    Average Dist =
    Var D = CALCULATE( sum(EmpDistance[Distance]),ALLEXCEPT(EmpDistance,EmpDistance[Job],EmpDistance[PAY_RUN]))
    Var E = CALCULATE(
        COUNT(EmpDistance[EmpID]),ALLEXCEPT(EmpDistance,EmpDistance[Job],EmpDistance[PAY_RUN])) - COUNTBLANK(EmpDistance[Distance])
    Return DIVIDE(D,E)
    And it works

    Thanks

    Oded Dror