Forum Discussion
Helper IIOn-premises gateway, using R?
Hi!
I saw this article from 2018, saying that it is not possible to load your data throug R with an on-premises gateway.
https://www.sqlgene.com/2018/09/25/power-bi-error-r-cannot-be-added-to-gateway/
Has there been any changes, or will there be any changes to allow this?
Regards
Marit
Hi Marit ,
R and Python scripts are supported for personal mode gateway.
https://docs.microsoft.com/en-us/power-bi/connect-data/service-gateway-personal-mode
You could take a look at this case for more information.
Did I answer your question ? Please mark my reply as solution. Thank you very much.
If not, please upload some insensitive data samples and expected output.
Best Regards,
Eyelyn Qin
3 Replies
- amitchandak
Super User
Marit , Gateway is required for power bi service. Refer this topic -https://community.powerbi.com/t5/Service/Publishing-R-visual-into-Power-BI-Service-Run-time-error-RODBC/td-p/475079
Seem like there list of r package supported on power bi service.
MaritI'm sorry. I asked the question in the wrong place. Thank you for your help anyway!
Hi Marit ,
R and Python scripts are supported for personal mode gateway.
https://docs.microsoft.com/en-us/power-bi/connect-data/service-gateway-personal-mode
You could take a look at this case for more information.
Did I answer your question ? Please mark my reply as solution. Thank you very much.
If not, please upload some insensitive data samples and expected output.
Best Regards,
Eyelyn Qin
