Forum Discussion
Helper IIIHierarchy Slicer - scroll not working
When all the options are expnded, the scroll is not working and unabling to check the last few values. Below is the snapshot of it.
Please let me know if you have any tricks or tips to solve this.
Appreciate your help and support in advance.
8 Replies
After investigation, it appears that if the slicer has a height of over 265 the scroll bar starts misbehaving
NKotak_LeecareYes, similar results show at my end as well. It also depends on the size of the dataset (number of values in a filter), so specific dimensions of the filter would work for one dataset but won't work for the other. Therefore, when you change the source of data, you might need to check the dimensions of the filter for displaying everything. For some datasets, lesser the size of the filter would display everything till the end.
- amitchandak
Super User
NKotak_Leecare , Just try to use the tab or down arrow key. if that can help
- NKotak_Leecare
Thanks for your response amitchandak . I tried working with tabs and down arrow key, however, it is not working. Is there any other solution? Thanks!
Hi NKotak_Leecare ,
I create a sample to have a test and I seem that couldn't reproduce the issue. You see the scroll down function works well in my side.
As the HierarchySlicer is developed by Jan Pieter Posthuma, I would suggest you contact the author for help by sending email to [email protected] as suggested here.
Best Regards,
Rico ZhouIf this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
Hi NKotak_Leecare ,
Did you find a solution to this as I am experiencing the same issue
Kind regards
Stuart
I also face same problem.
I my case I change the height in 180 and it works properly. You can also change height in less than 250. Hopefully it works
