Filters - toggle vs. multiple

Hi Anonymous ,

When you select all the values in the Filter_Value_multiple1 slicer, it will filter the following rows in the Filter table:

          Filter_Value_toggle = "A"

         AND

         (Filter_Value_multiple1 = "is_friendly" OR Filter_Value_ multiple1 = "is_listed" OR Filter_Value_multiple1 =                      "is_regional")

So both ACM1 and Gwanz are displayed.

Similarly, when you select "is_listed" and "is_regional", the result is as follows.

If the problem is still not resolved, please provide detailed error information or the expected result you expect. Let me know immediately, looking forward to your reply.

Best Regards,
Winniz

If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

Hi Anonymous ,

If you need to only show "Gwanz" when you select "is_friendly", "is_listed" and "is_regional", I think you need use the measure and filter it when the result is not blank.

Measure = 
IF(
    COUNTX(
        ALLSELECTED('Table'[Filter_Value_multiple1]),
        'Table'[Filter_Value_multiple1]
    ) 
    = 
    CALCULATE(
            DISTINCTCOUNT('Table'[Filter_Value_multiple1]),
            ALLSELECTED('Table'[Filter_Value_multiple1])
        ),
    1
)

Best Regards,
Winniz