Forum Discussion

Anonymous's avatar
Anonymous
Not applicable
6 years ago
Solved

Filtering a table based on Map selection

I've seen similar threads based on slicer selection, but belieive this is sufficiently different to warrent a seperate thread (at least the dax solutions for a slicer don't seemt to apply here).   ...
Need Help
  • v-alq-msft's avatar
    v-alq-msft
    6 years ago

    Hi, Anonymous 

     

    Based on your description, I created data to reproduce your scenario. The pbix file is attached in the end. 

    Table:

     

    Map:

     

    You may create a measure as below.

    Visual Control = 
IF(
    ISFILTERED(Map[Location]),
    IF(
        SELECTEDVALUE('Table'[Location]) in DISTINCT(Map[Location]),
        1,0
    ),
    0
)

     

    Finally you need to put the measure in the visual level filter to get the result.

     

     

    Best Regards

    Allan

     

    If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

v-alq-msft's avatar
v-alq-msft
Icon for Community Support rankCommunity Support
6 years ago

Hi, Anonymous 

 

Based on your description, I created data to reproduce your scenario. The pbix file is attached in the end. 

Table:

 

Map:

 

You may create a measure as below.

Visual Control = 
IF(
    ISFILTERED(Map[Location]),
    IF(
        SELECTEDVALUE('Table'[Location]) in DISTINCT(Map[Location]),
        1,0
    ),
    0
)

 

Finally you need to put the measure in the visual level filter to get the result.

 

 

Best Regards

Allan

 

If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

Anonymous's avatar
Anonymous
Not applicable
6 years ago

Lot's of answers here which i'm sure would work, so thank you all.

This answer in particular with the attached figures and pbix as an example were very easy to follow and exactly what was needed. Thanks