Forum Discussion
Enable/disable load in Reference and Duplicate
Hello everyone,
I am a little confused with the difference between Reference and Duplicate.
Lets take an example here,
If I have a table say A which is connected to a datasource say SharePoint and a table B which is a reference of table A.
If I disable load of table A and refresh table B, it gets refreshed, so it means that table B can exist independently.
My concern here is, what is the point of having duplicate then?
Hi Anonymous
You may check this thread for reference. Here is the document about Reference vs Duplicate.
Regards,
Cherie
2 Replies
- Greg_Deckler
Community Champion
Duplicate duplicates all of your M code, providing you a starting point to make changes whereas Reference creates a reference to the original query.
v-cherch-msftMicrosoft Employee
Hi Anonymous
You may check this thread for reference. Here is the document about Reference vs Duplicate.
Regards,
Cherie
