Forum Discussion
Dataflows (Gen1 and Gen2) failing
Hello,
today all my Dataflows Gen1 & Gen2 started failing. The job runs for a couple of minutes then it shows up as failed in the history with 0 seconds runtime. Error messages are not helping:
"There was a problem refreshing the dataflow. Please try again later. (Request ID:xxx"
Anybody having the same problem?
I created a support ticket yesterday, but haven't heard back. also I did see some posts on r/MicrosoftFabric yesterday of other Fabric users having the same problem with dataflows.
Today everything is back to normal.
This is certainly not reassuring - as those Dataflows only used data from Fabric sources without Gateway and they have been running for months without problems... I am pretty sure this issue was not cause by my configuration...
3 Replies
Hi chris__1 ,
In my environment, everything works fine with refreshing the dataflow(Gen1 and Gen2). What is your data source, where is it coming from, and are you checking that everything is OK with the gateway? Are you able to provide relevant screenshot information and describe it so that I can answer it for you as soon as possible.
Best Regards,
Adamk KongIf this post helps, then please consider Accept it as the solution to help the other members find it more quickly.
I created a support ticket yesterday, but haven't heard back. also I did see some posts on r/MicrosoftFabric yesterday of other Fabric users having the same problem with dataflows.
Today everything is back to normal.
This is certainly not reassuring - as those Dataflows only used data from Fabric sources without Gateway and they have been running for months without problems... I am pretty sure this issue was not cause by my configuration...
