Forum Discussion
DataflowGen2, which does not copy all the data...
Hello vivien57
First, can you try to only select a few columns
Then, to check if the issue is comming from dataverse OR on fabric side, could you try to execute it in a dataflow gen 1 and check if in your Power BI report you retrieve all data ?
Keep us inform about the results
Hello,
Thank you for your feedback.
By randomly removing 87/366 columns I have managed to read and write 32.152 lines on 70.037 lines.
By randomly removing 151/366 columns I have managed to read and write 54.922 lines on 70.037 lines.
By randomly removing 364/366 columns I have managed to read and write 70.037 lines on 70.037 lines.
So there seems to be a link between the number of columns and this problem.
These tests were done on an F2 capacity, I've tried on an F64 capacity, which doesn't solve the problem.
Do you have any idea what the problem is? It seems to come from DataflowGen2....
Thank in advance,
Vivien
Hello v-saisrao-msft ,
No the issue is not resolved. I have tested again, and it's the same.
Thank in advance,
Vivien
Would you mind raising a support ticket so an engineer can take a closer look at your scenario and collect all the information to troubleshoot ? Below is the link to raise the support ticket:
