Forum Discussion

amolt's avatar
amolt
Resolver I
2 years ago

Dataflow runs for hours

Hello,
I regularly have Gen2 dataflows that get stuck in refresh mode for hours on end, consuming all the resources of my capacity. Under normal circumstances, these dataflows only last a few minutes (they only load one table from a cvs).
I tried to restart the gateway, without success.
What can I do?

 

Thanks for your help

Dataflows
Need Help

9 Replies

  • DataPne's avatar
    DataPne
    Frequent Visitor
    2 years ago

    I am having the same issue - support hasn't been able to help other than suggesting not to use Gen2 dataflows.

    Not really feasible - surprising how bad this product is.

  • HimanshuS-msft's avatar
    HimanshuS-msft
    Microsoft Employee
    2 years ago

    Hello amolt 
    Thanks for using the Fabric community.

    As I understand the current inquiry, the question is why Dataflow Gen2 is taking more time than usual. Please correct me if I'm mistaken.

    You mentioned that it's 'consuming all the resources of my capacity,' which seems unusual and suggests that there may be other activities occurring concurrently, such as another scheduled data flow. If you're uncertain, you could attempt to reschedule the Dataflow during off-hours to see if this adjustment results in fewer failures.

    Thanks
    HImanshu

    • amolt's avatar
      amolt
      Resolver I
      2 years ago

      Hello HimanshuS-msft ,
      Thank you for your reply.
      No, I don't have any other treatment in parallel. During this last execution, the dataflow lasted more than 5h against a few minutes usually.

       

      Thanks

      • amolt's avatar
        amolt
        Resolver I
        2 years ago

        Hi DataPne , Joshrodgers123 ,

        Do you use a pipeline to execute your dataflows ?
        In my case, I noticed that my problems came when I used a pipeline to schedule the execution of the gen2 dataflow.

  • Joshrodgers123's avatar
    Joshrodgers123
    Advocate V
    2 years ago

    I have the same issue trying to load from on-prem SQL Server with the latest gateway. 

     

    With a gen 1 dataflow, the table loads in a couple seconds. With gen2 and staging enabled, it takes a few minutes. Turning off staging, which I'd like to do since the query can fold, it takes an hour and a half and fails 9 out of 10 times.

  • v-cboorla-msft's avatar
    v-cboorla-msft
    Microsoft Employee
    2 years ago

    Hi amolt 

     

    Following up to check if you have a resolution yet. In case if you have any resolution please do share the same with community as it can be helpful to others.
    Otherwise, will respond back with the more details and we will try to help .

     

    Thanks

    • amolt's avatar
      amolt
      Resolver I
      2 years ago

      Hi v-cboorla-msft ,

      Unfortunately I have no other solution than not to use pipelines to run Gen2 dataflow.

       

      Thanks