Forum Discussion
Activator Reflex Trigger based on Pct Increase not Activated
I have "percent increase-based" rules that are not being triggered. Rules based on the same attribute but using a "greater than or equal to" condition work fine. I can't figure out if this is a bug or if I'm not understanding how to use the "Increases by" condition with a percent.
Rule type 1: Attribute "Is greater than or equal to" some value. This works.
Rule type 2: Attribute "Increases by" X percent.
Duration (m) is duration in minutes. The value ranges from about 3 to 9 and I have many instances where it's gone from 4 to 6, which would be a 50% increase if I'm doing the math correctly.
Hi delish_hins,
In this case please consider raising a support ticket for further assistance. To raise a support ticket with Fabric and Power BI, kindly follow the steps outlined in the following guide:
How to create a Fabric and Power BI Support ticket - Power BI | Microsoft Learn
Thanks,
Prashanth Are
6 Replies
v-prasareCommunity Support
Hi delish_hins,
Thanks for reaching out to MS Fabric community support
please take check below points and let me know if this helps resolve your issue?
-
Check for rounding: Look into the precision of the values being used. If your values are rounded, it could prevent the percentage increase from meeting the threshold.
-
Test with different increments: Try using smaller increments, such as 10% or 25%, and see if the rule triggers. This could help isolate whether the issue is related to the specific 50% increase.
-
Check time and rate of change: Double-check that the increase occurs over the expected time frame, and that the rate of change you're observing is correctly aligned with the percentage increase.
Thanks,
Prashanth Are
MS Fabric community support
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly and give Kudos if helped you resolve your query
I've tried these steps and they did not work unfortunately.
-
- v-prasare
Hi delish_hins, As we haven’t heard back from you, we wanted to kindly follow up to check if the solution provided for your issue worked? or let us know if you need any further assistance here?
Thanks,
Prashanth Are
MS Fabric community support
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly and give Kudos if helped you resolve your query
- v-prasare
Hi delish_hins,
As we haven’t heard back from you, we wanted to kindly follow up to check if the solution provided for your issue worked? or let us know if you need any further assistance here?
Thanks,
Prashanth Are
MS Fabric community support
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly and give Kudos if helped you resolve your query
- v-prasare
Hi delish_hins,
In this case please consider raising a support ticket for further assistance. To raise a support ticket with Fabric and Power BI, kindly follow the steps outlined in the following guide:
How to create a Fabric and Power BI Support ticket - Power BI | Microsoft Learn
Thanks,
Prashanth Are
- v-prasare
We are following up once again regarding your query. Could you please confirm if the issue has been resolved through the support ticket with Microsoft?
If the issue has been resolved, we kindly request you to share the resolution or key insights here to help others in the community. If we don’t hear back, we’ll go ahead and close this thread.
Should you need further assistance in the future, we encourage you to reach out via the Microsoft Fabric Community Forum and create a new thread. We’ll be happy to help.
Thank you for your understanding and participation.
